What year is.
Rv awning motor troubleshooting.
Remove the front and back covers from the motor on the right side of the awning.
We repair maintain and service all other chassis.
Step 5 repair fabric.
We sell install and repair all major brands of rv awnings and related products.
Mcbride s rv provides a scheduled maintenance for rvs.
If your rv awning canopy sags in some areas check the rivets that are holding the torsion assembly in place.
The rv is a 2013 palomino puma by forest river.
By doing this the motor should start to operate and extend or retract the awning.
There are other problems that are not a part of the mechanics of the motorized awning.
I extended the awning with no problem.
Also a warranty provider for workhorse chassis and spartan chassis.
Before you replace the fuse test it with a multimeter set to the continuity setting or take it into an auto parts store and they will test it.
Broken rivets are those that no longer have heads.
Sagging canopy is one of the common problems you may encounter with your rv awning.
Locate the supply connection terminal on the motor and connect it with the battery supply wires that you will have.
And now it just clicks and won t retract.
At the motor on the right side of the awning just happened.
Loosen the bolts holding it in place and lift it out of the housing.
Replace all broken rivets and put the torsion assembly in the right position.
I tried the awning using it and it worked.
This told me the motor and wiring to the awning was good.
Do this on both ends.
We specialize in rv awnings and have served the rv industry in southern california since 1989.
We offer mobile service at your home business storage site or campsite.
Tie the awning arms off to the bracket where it attaches to the side of your rv.
This prevents the awning from unrolling completely when the motor is removed.
However they are just as frustrating.
What is the model year of your rv.
Use the manual override if the motor is completely dead.
Connect the chain for the awning and plug into the electrical supply.
Unbolt the chain from the drive shaft of the awning motor.
I disassembled the control panel and swapped the slide out room switch it uses the same switch with the power awning switch and the fault swapped as well.
The awning states that it was manufactured october 27th 2011.
If it did show 12 v then that means the awning wiring is fine and the issue lies with the motor.
Install a new motor and tighten the bolts.
Repairing the rv awning power switch.
