Butt the edges together instead of overlapping them.
Roofing starter strip installation.
Roofing underlayment and drip edge have of course been applied first.
Perforated down the center for easy separation.
The nails are 1 1 2 to 3 above the bottom edge of the roof.
Use with any shingle that has an exposure of up to 6.
The continuous sealant ensures an effective seal between the starter and the first course of shingles.
Speeds installation and helps improve safety.
It stops water from getting through to the roof at the gaps between shingles and at the notches between tabs.
A superior alternative to starter shi.
Gaf pro series starter strip shingles valley hip install.
The half width full length starter strip is nailed with a 1 4 to 1 1 4 overhang past the drip edge or roof edge.
Do not penetrate the shingles with the hammer.
It is packaged two pieces per shingle 16 shingles per bundle.
Notice where the nails are placed on these special starter strips.
Owens corning starter strip shingle helps save time by eliminating the need to cut shingles to create a starter row.
Installation of the manufacturer s starter shingle is convenient and is the best product to use as the starter course.
Starter strip shingle advantages.
Historically starter strip shingles have been used not only at the lower eave edge of the roof but experienced professionals also use them at the gable or rake edges of roofs.
It s easy for a single person to position starter strip shingle on the roof.
You will want the roof granular side up when applying the strip.
The end should overhang over the edge about 1 4 to 3 4 of an inch.
You can save a few bucks using pre cut starter strips instead of using a whole shingle.
Quick installation tips for how to install gaf starter strip shingles on a roof.
Starter strip shingle eliminates the need to cut off tabs or headlap.
Detailed installation of starter strip shingles at the valleys and hips.
Gaf mastering the roof chapter 09 this video demonstrates the proper installation technique for gaf starter strips.
It s not complicated and you do not ne.
Continuing with the starter shingles.
At the eave the starters provide a simple way to cover the joints between the finish shingles in the first course ensuring complete water shedding roof coverage.
Before peeling the shingle starter strip trim about 4 inches off an end of the first starter strip and align the strip to the area you are planning to stick it on.