Roof Anchor Installation Instructions

Both permanent and temporary roof anchor points are available.

Roof anchor installation instructions.

Anchor points are usually installed on the roof and are used to connect lanyards lifelines and other forms of tie off which prevent a worker from falling. Each roof anchor installation must be independently capable of sustaining this load. The silicone will spread and adhere creating a seal. Applied in any direction permitted by the restraint system when in use.

In general roof anchors should be installed on roofs or structures that are made of wood and sheathing. You may need to cut panels to fit angles using a circular saw with a metal saw blade. Installation guidelines for different slopes categories are listed below. Each of our roofing technicians has received extensive training to properly install roof anchors within the rules and regulations of osha.

Roof anchors installed for restraint applications must be attached to a roof member capable of sustaining a static load of at least 3 000 lbs. Screw the new panel in place as described. Roof anchors can be as simple as a d ring connection or as complex as a complete lifeline system. If the material is not able to support 5 000 lbs.

Metal roofing is also available in the form of shingles. B install anchordeck synthetic roofing underlayment without wrinkles. Always install the anchor device so no part of the device is less 2 5 m from the edge of the roof or opening. Minimum tensile load a qualified person must confirm that the support structure maintains a safety factor of two as per osha 1926 502.

If two roof anchors are installed onto a roof structure each anchor location must be independently capable of supporting 5 000 lbs. 3 0 operation and use. Slopes 4 12 and more a lay out anchordeck synthetic roofing underlayment horizontally parallel to the eave with the printed side up. Install the panel so that the short lip overlaps the large lip.

Installation of this roof anchor must be certified by a qualified person or engineering service. More than one roof anchor is installed to a roof structure the strengths given in a or b above must be met at each roof anchors installation point independently. 2 way roof anchor installation instructions this product is part of a personal fall arrest system. The users must read and abide by the manufacturer s instructions for each element of the system.

The roof material must be capable of supporting a minimum tensile load of 5 000 lbs. Do not stretch during installation. Not for use as an abseiling point. Lay flat cap nail flat.